Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. Issue the eigrp stub command on R1.
• B

  B. Issue the no eigrp stub command on R1.
• C

  C. Issue the eigrp stub command on R2.
• D

  D. Issue the no eigrp stub command on R2.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. R1 sees 192.168.130.0/24 as two AS hops away instead of one AS hop away.
• B

  B. R1 does not accept any routes other than 192.168.130.0/24
• C

  C. R1 does not forward traffic that is destined for 192.168.30.0/24
• D

  D. Network 192.168.130.0/24 is not allowed in the R1 table

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. nonbroadcast multiaccess
• B

  B. packet switching
• C

  C. policy-based routing
• D

  D. forwarding information base

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. Dynamic routing protocols always have priority over static routes.
• B

  B. The metric of the OSPF route is lower than the metric of the static route.
• C

  C. The configured AD for the static route is higher than the AD of OSPF.
• D

  D. The syntax of the static route is not valid, so the route is not considered.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. The summary-address command is used only for summarizing prefixes between areas.
• B

  B. The summary route is visible only in the OSPF database, not in the routing table.
• C

  C. There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.
• D

  D. The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. Use an extended access list instead of a standard access list.
• B

  B. Change sequence 10 in the route-map command from permit to deny.
• C

  C. Use a prefix list instead of an access list in the route map.
• D

  D. Add this statement to the route map: route-map RM-OSPF-DL deny 20.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Answers

Correct answer and vote data stay hidden until you click reveal.

• A

  A. Jumbo frame support must be configured on the router that is using BFD.
• B

  B. All routers in the path between two BFD endpoints must have BFD enabled.
• C

  C. Cisco Express Forwarding must be enabled on all participating BFD endpoints.
• D

  D. To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.